STANDARD SPECIFICATION -High efficiency on heavy plate bending operation -Reduced overall dimensions and easiness of transportation on medium and big machines -Having the two bottom rolls horizontally moving, means also a lower working height which requires a smaller foundation pit and less anchoring load (in the smallest models you don’t need foundation) -On smaller no need to place by digging. - During operation (pre-bending and bending phases), the plate always keeps its horizontal position. So material move more easily -The solid construction and the particular geometry of the model enable to be used as a press brake bending machine -This machine can fulfill the best pre-bending on every required diameter. -The possibility to reduce centre-distance between lower rolls realizes a better pre-bending during bending of tubes with small diameter and thickness - Another important future of thismachine is the operating system of the top forming roll. In fact, the top forming roll can be used as a traditional press brake allowing perfect re-rolling and calibration operations of the produced tubes -In the same way it is also possible to obtain cones with heavy thickness by bending in several strokes the plate - With some 3 and 4 rolls pyramidal machines it is necessary to tilt the top roll to allow the produced tube removal. On the this machine this is not necessary and therefore it is much more easier to remove the finished tube - Large working stroke allows to get best bending result -Can bend thicker plates compare to equivalent 3 or 4 roll machines -Induction hardened forged or rolled - Conical Bending device OPTIONAL ACCESSORIES -Overhead crane for big diameters -Hydraulic lateral side support for big diameter